Home Page link

Finishing trim on a new shower? - Page 3

Building Construction - Building Construction Industry Discussions. 

Page 3 of 3       << first < 1 2 3 Bookmark this page:  YahooMyWeb Yahoo!  Google Google  Windows Live Favorites Windows Live  del.icio.us del.icio.us  digg digg  Add to Netscape Netscape
Subject Author Date
Finishing trim on a new shower? SparkyGuy 12-15-2006
If you were  Registered and logged in, you could reply and use other advanced thread options
Posted by HerHusband on December 16, 2006, 1:17 pm
> Just finished installing a shower in an existing bathroom that
> previously had only toilet & sink.
> 1-piece shower shell placed in corner against 2 existing sheet rock
> walls. Added floor-to-ceiling stud wall on 3rd side of shower.
> I've calked and screwed the shell to the 3 walls. Now I'm not sure
> what the best way is to trim above the shell and along the front edges
> where it is attached to the 2 side walls.

Cedar trim.

Paint the wall first, then rabbet the back side of the trim so it sits flat
over the shower flange, nail it up (careful not to nail through the shower
flange), and cover with a couple of coats of spar urethane.

Normally, you wouldn't want to use wood near a shower, but this should be
outside the majority of the wet areas. In any case, the cedar would hold up
better than the drywall in the area.

Installing trim would also let you remove and replace the shower stall
easily in the future if you needed to (let's hope that's not any time
soon).

Of course, you could paint the trim to match your room, or use a router to
create a decorative profile. Your choice.

Anthony

Posted by John Reddy on December 17, 2006, 7:44 am

> Paint the wall first, then rabbet the back side of the trim so it sits flat
> over the shower flange, nail it up (careful not to nail through the shower
> flange), and cover with a couple of coats of spar urethane.

Put one coat of urethane on before you nail it up and cover all six
sides of the trim. Apply additional coats after it is in place.

Page 3 of 3       << first < 1 2 3
Similar ThreadsPosted
Finishing a basement: I want to paint the walls BEFORE installing doors and trim August 5, 2008, 10:50 pm
Gable trim and porch beam trim--advice? October 25, 2006, 9:00 am
Butt Siding to Corner Trim, or cover siding with corner trim? July 19, 2009, 11:21 am
finishing an attached garage July 10, 2009, 11:37 am
Finishing basement, insulation question August 20, 2006, 10:29 am
finishing basement with infloor heat.. September 6, 2007, 11:20 am
finishing basement floor question June 6, 2008, 1:27 pm
finishing concrete sidewalk curbs August 29, 2008, 12:40 am
Finishing garage with truss roof system May 14, 2007, 11:48 am
Owens Corning Basenent Finishing System August 12, 2007, 4:03 pm

Contact Us | Privacy Policy

XML SitemapXML Sitemap