|
Posted by DerbyDad03 on March 30, 2008, 3:32 pm
>
>
>
> > If you lift the front edge of the board slightly, you can easily
> > complete the cut on a 2 x 6 on a saw that only claims a DOC of 5 3/8".
> > Make your cut with the board flat, then just tilt the board up enough
> > so that a few more teeth on the front of the blade complete the cut.
>
> > I do it all the time with my Delta 10" non-slider.
>
> > ******************************
>
> > I can see nasty repercussions if not done properly though.
>
> That statement applies to the use of *so* many power tools as well as
> *so* many other situations in our daily lives.
>
> BTW...after I posted my method, I was watching one of the multitudes
> of "home" shows on TV and so one the supposed experts apply the same
> technique.
>
> *****************************
>
> That may be true, but I'm still not going to advise someone that may have
> never used a power saw to turn the board while the blade is spinning at hi=
gh
> rpm.
re: turn the board
Are you sure we're talking about the same thing? Are you equating my
use of the word "lift" with "turn"?
I would never tell someone to *turn* a board while cutting it, unless
it was a scroll or band saw...
=2E..or if they were cutting a circle on a table saw.
I just did that for my daughter last weekend. Cut her a perfectly
round 17" circle out of 3/4 MDF. I love that technique.
| 
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML Sitemap