If you were Registered and logged in, you could reply and use other advanced thread options
|
Posted by on October 17, 2007, 5:44 am
> What's the installing dealer have to say?-
He's, literally, unresposive. May have gone out of business, or may
be exceedingly unprofessional to not reply after 3 phone calls over
the course of a month.
|

| |
Posted by The Freon Cowboy on October 17, 2007, 6:53 am
Thats too bad , maybe you could pay him a visit in person ?
its really hard to diagnose a problem as yours over a keyboard
heres some obvious things , then you'd better consider getting somebody over
there who can figure it out without damaging it or your property
1. boiler piped properly ?
2.circulator installed properly ? there will be an arrow on the cast iron body
indicating direction of water flow , the arrow should be pointed toward the
direction of water that will take it into the bottom hole on the boiler .
3, air , tony mentioned it , but you could still have air trapped soemwhere
can you hear water flowing through your radiators
all my other ideas involve electrical and low voltage wiring , which i wont
get into with you ,
the three things i mentioned above are easy and involve simple visual
inspection ,
see what you can find out , otherwise and unfortunately you may have to pay a
competent boiler tech to suss out your problem
good luck
anthonymmfalcone@yahoo.com wrote:
>> What's the installing dealer have to say?-
|
|
Posted by Bubba on October 17, 2007, 7:43 am
On Wed, 17 Oct 2007 02:44:02 -0700, anthonymmfalcone@yahoo.com wrote:
>> What's the installing dealer have to say?-
>
>He's, literally, unresposive. May have gone out of business, or may
>be exceedingly unprofessional to not reply after 3 phone calls over
>the course of a month.
Isnt the cheapest bidder just wonderful?
Bubba
|
|
Posted by Noon-Air on October 17, 2007, 9:44 am
>> What's the installing dealer have to say?-
>
> He's, literally, unresposive. May have gone out of business, or may
> be exceedingly unprofessional to not reply after 3 phone calls over
> the course of a month.
>
Call around to the various suppliers for that particular boiler, and tell
them whats going on. Ask them if they know what happened to the installer.
Also ask them who's the best tech they got and go from there.
No its not gonna be free, and probably not gonna be cheap. Just consider it
the offset between the lowest bidder, and having it done by a *competent*,
licensed, insured, professionally trained, HVAC technician.
|
|
Posted by ransley on October 17, 2007, 2:51 pm
>
installing dealer have to say?-
>
> > He's, literally, unresposive. May have gone out of business, or may
> > be exceedingly unprofessional to not reply after 3 phone calls over
> > the course of a month.
>
> Call around to the various suppliers for that particular boiler, and tell
> them whats going on. Ask them if they know what happened to the installer.
> Also ask them who's the best tech they got and go from there.
> No its not gonna be free, and probably not gonna be cheap. Just consider it
> the offset between the lowest bidder, and having it done by a *competent*,
> licensed, insured, professionally trained, HVAC technician.
Why not try Burnham first, you have a warranty.
|
Page 2 of 11 < 1 2 3 > last >>
| Similar Threads | Posted | | Ideas about strange behavior of Bosch 250SX Tankless? | April 11, 2006, 10:56 pm |
| Boiler temperature; adjust? - Weil-McLain GOLD GV series 4 | December 17, 2006, 9:14 pm |
| Any boiler OWNER save money after converting to a high efficiency boiler? | August 6, 2006, 11:25 am |
| More Than 20 Very Strange Tools | October 4, 2007, 11:50 am |
| Some Very Strange Tools | October 6, 2007, 11:33 am |
| Re: Very Strange Tools (What Are They?) | October 29, 2007, 6:45 pm |
| when condenser starts it makes a strange noise | July 9, 2006, 12:34 pm |
| home buyer with questions about a strange heating setup | March 7, 2007, 8:55 pm |
| 18 Very Strange Houses (Not HVAC directly, but you may enjoy imagining the challenges) | October 3, 2007, 9:57 am |
| Discharge temperature | August 11, 2006, 11:39 pm |
|
|