Need help installing my own furnace

Posted by Stormin Mormon on January 22, 2007, 10:11 pm

Agreed, that Dyier fellow is probably not a HVAC professional.

Don't accept advice from center posters.

--

Christopher A. Young
You can't shout down a troll.
You have to starve them.
.

message

> > I'd suggest that you watch out for inadequate size or quality

> > materials. Watch out for distances travelled, and improper
> > bonding methods.

> Also, watch out for the guy listed below.

> > Christopher A. Young
> > You can't shout down a troll.
> > You have to starve them.
> > .

> > > I am looking to install an XL90 furnace -- but before I

start,

> > I would

> > > like to get some pointers on what I need to watch out

for...

Posted by B-Hate-Me on January 25, 2007, 11:40 pm

> Agreed, that Dyier fellow is probably not a HVAC professional.
> Don't accept advice from center posters.

Ya.......Or whacko religious kooks like the mormun.

Posted by on January 26, 2007, 1:56 am

> Agreed, that Dyier fellow is probably not a HVAC professional.
> Don't accept advice from center posters.

Or the DICKHEAD listed above... named "Jackoff" Chris... AKA "Stormin Moron"

Posted by Stormin Mormon on January 26, 2007, 8:18 am

Well, maybe I didn't miss you after all.

--

Christopher A. Young
You can't shout down a troll.
You have to starve them.
.

message

> > Agreed, that Dyier fellow is probably not a HVAC

professional.

> > Don't accept advice from center posters.

> Or the DICKHEAD listed above... named "Jackoff" Chris... AKA

"Stormin Moron"

Posted by Hans on January 22, 2007, 3:24 am

>I am looking to install an XL90 furnace -- but before I start, I would
> like to get some pointers on what I need to watch out for...

Key points:

1. Size it properly and follow the install manual.

2. Slope the PVC 1/4"/ft back towards the furnace and check max venting
length for the pipe size, don't forget to include the elbows. Use primer for
the glue and terminate outside properly and make sure the pipes are
supported as per the manual.

3. Check that heat rise and firing rate are within specs

4. Get it inspected!

5. Check all joints for gas leakage.

6. Ensure proper drainage for the condensate

7. Install a good quality CO alarm.

8. Take a nice all-inclusive vacation with the $3,000-4,000 saved

Page 5 of 6 < 1 2 3 > last >>

Similar Threads	Posted
DIY INstalling furnace ductiwork in new home	September 22, 2006, 6:46 am
Installing Central Air in house with Oil Furnace help needed	June 20, 2007, 8:25 am
Installing split AC system	July 20, 2006, 5:06 pm
Problem Installing Thermostat	November 28, 2006, 2:21 pm
Installing a propane gas log set in a fireplace.	January 8, 2007, 10:01 am
Installing a propane gas log set in a fireplace.	January 8, 2007, 10:01 am
Installing "Classic" Hunter Fan (?)	January 9, 2007, 6:30 am
What brand 410 A are you guys installing?	May 10, 2008, 12:04 am
Installing a ceiling register boot	July 3, 2006, 4:48 pm
Installing a new spit system tomorrow...	July 11, 2006, 1:31 am

Need help installing my own furnace - Page 5