If you were Registered and logged in, you could reply and use other advanced thread options
|
Posted by <kjpro on October 28, 2007, 12:29 am
show/hide quoted text
> > > Thanks for your advice, Bob.
> > > We have our own well, with an ozone filter, but no other type.
> > > We are in a very rural area, about 2 hours from a town big enough to
> > > have Home Depot/WalMart, and it's hard to find any qualified HVAC
> > > people who are willing to come out to the boondocks.
> > > Our electric rate is about .14/kw (I think), and propane is about the
> > > same as the high grade oil our burner uses.
> > > As for those of you suggesting moving from CA, well, as a retired high
> > > school teacher, living on a small pension, I wish it was so easy to
> > > sell a house and move somewhere else, but houses are not selling very
> > > well right now. And where else would we go? Everywhere you need either
> > > heat or AC, so we are lucky that we don't need AC, and only need heat
> > > to go from 40 up to 65, not 20 or 0, like most northern places.
> > Which is *why* I posted that you get a H/P!!!!!!!!
> > $3.40 fuel oil is costing you $3.06 per 100 K into your home at 80%
> > efficiency.
> > $3.40 fuel oil is costing you $2.72 per 100 K into your home at 90%
> > efficiency.
> > LP at $3.00 will cost you $4.09 per 100 K at 80% efficiency.
> > LP at $3.00 will cost you $3.63 per 100 K at 90% efficiency.
> > Electric Heat at 14 cents per kwh will cost you $4.09 per 100 K into
your
show/hide quoted text
> > home.
> > Now, run a heat pump in 65 degree weather with a
> > COP of 3.5 and the cost is $1.17 per 100 K into your home.
> > (62% savings over your current 80% fuel oil)
> > Or run a heat pump in 45 degree weather with a
> > COP of 3.2 and the cost is $1.28 per 100 K into your home.
> > (59% savings over your current 80% fuel oil)
> > Or run a heat pump in 37 degree weather with a
> > COP of 3.0 and the cost is $1.36 per 100 K into your home.
> > (56% savings over your current 80% fuel oil)
> > Now tell me, who wouldn't like to cut their heating cost in half?
> > Are you on the phone to get a proposal for a new H/P yet?
> > The real question is, if your not, why aren't you?
> I just checked with my HVAC installer/repair guy.
> He agrees that a H/P would be good, if it can be installed inside a
> shed, not out in the salt air, where it would rot in no time.
> He also says that the on-demand system would save us money on our
> current overall bill, even though oil provides more BTUs/gal than LP
> does.
> Thanks for your valuable response.
> regards,
> socoast
Tell your install/repair guy that he's FULL OF SHIT, then go find a
*competent* one!
|
|
Posted by Bob Pietrangelo on November 2, 2007, 3:24 pm
Bullshit to the too much Salt Issue. IF he is that worried about it, he can
have the Unit dipped. I strongly reccomend a Trane unit if it is seaside
--
Bob Pietrangelo
bobp3@comcast.net (home)
bob@comfort-solution.biz (work)
www.comfort-solution.biz
show/hide quoted text
>> > Thanks for your advice, Bob.
>> > We have our own well, with an ozone filter, but no other type.
>> > We are in a very rural area, about 2 hours from a town big enough to
>> > have Home Depot/WalMart, and it's hard to find any qualified HVAC
>> > people who are willing to come out to the boondocks.
>> > Our electric rate is about .14/kw (I think), and propane is about the
>> > same as the high grade oil our burner uses.
>> > As for those of you suggesting moving from CA, well, as a retired high
>> > school teacher, living on a small pension, I wish it was so easy to
>> > sell a house and move somewhere else, but houses are not selling very
>> > well right now. And where else would we go? Everywhere you need either
>> > heat or AC, so we are lucky that we don't need AC, and only need heat
>> > to go from 40 up to 65, not 20 or 0, like most northern places.
>> Which is *why* I posted that you get a H/P!!!!!!!!
>> $3.40 fuel oil is costing you $3.06 per 100 K into your home at 80%
>> efficiency.
>> $3.40 fuel oil is costing you $2.72 per 100 K into your home at 90%
>> efficiency.
>> LP at $3.00 will cost you $4.09 per 100 K at 80% efficiency.
>> LP at $3.00 will cost you $3.63 per 100 K at 90% efficiency.
>> Electric Heat at 14 cents per kwh will cost you $4.09 per 100 K into your
>> home.
>> Now, run a heat pump in 65 degree weather with a
>> COP of 3.5 and the cost is $1.17 per 100 K into your home.
>> (62% savings over your current 80% fuel oil)
>> Or run a heat pump in 45 degree weather with a
>> COP of 3.2 and the cost is $1.28 per 100 K into your home.
>> (59% savings over your current 80% fuel oil)
>> Or run a heat pump in 37 degree weather with a
>> COP of 3.0 and the cost is $1.36 per 100 K into your home.
>> (56% savings over your current 80% fuel oil)
>> Now tell me, who wouldn't like to cut their heating cost in half?
>> Are you on the phone to get a proposal for a new H/P yet?
>> The real question is, if your not, why aren't you?
> I just checked with my HVAC installer/repair guy.
> He agrees that a H/P would be good, if it can be installed inside a
> shed, not out in the salt air, where it would rot in no time.
> He also says that the on-demand system would save us money on our
> current overall bill, even though oil provides more BTUs/gal than LP
> does.
> Thanks for your valuable response.
> regards,
> socoast
>
|
Page 6 of 6 << first < 1 2 3
| Similar Threads | Posted | | Gas Burner / Hot water system problem | November 20, 2006, 9:56 am |
| Non working 1982 GE Gas Fired Forced Air Furnace | January 29, 2008, 12:54 am |
| Replacing Natural Gas Forced Air Furnace in New York | January 24, 2007, 10:23 pm |
| Heating system and water heater exhaust | November 9, 2006, 8:45 pm |
| Clay Radiant Heater Fired by Bituminous Coal -- any Real-Life example? | September 11, 2009, 9:00 pm |
| Chilled water for residential forced air AC systems? | August 15, 2006, 6:05 pm |
| Baseboard Hot/chilled water vs. forced air: efficiency | October 22, 2009, 1:03 am |
| replacing old heating system | October 5, 2006, 5:23 pm |
| Replacing my existing system | June 12, 2008, 10:37 am |
| oil hot water heater CONVERSION for pool heater | January 4, 2008, 8:03 pm |
|
|
> > > We have our own well, with an ozone filter, but no other type.
> > > We are in a very rural area, about 2 hours from a town big enough to
> > > have Home Depot/WalMart, and it's hard to find any qualified HVAC
> > > people who are willing to come out to the boondocks.
> > > Our electric rate is about .14/kw (I think), and propane is about the
> > > same as the high grade oil our burner uses.
> > > As for those of you suggesting moving from CA, well, as a retired high
> > > school teacher, living on a small pension, I wish it was so easy to
> > > sell a house and move somewhere else, but houses are not selling very
> > > well right now. And where else would we go? Everywhere you need either
> > > heat or AC, so we are lucky that we don't need AC, and only need heat
> > > to go from 40 up to 65, not 20 or 0, like most northern places.
> > Which is *why* I posted that you get a H/P!!!!!!!!
> > $3.40 fuel oil is costing you $3.06 per 100 K into your home at 80%
> > efficiency.
> > $3.40 fuel oil is costing you $2.72 per 100 K into your home at 90%
> > efficiency.
> > LP at $3.00 will cost you $4.09 per 100 K at 80% efficiency.
> > LP at $3.00 will cost you $3.63 per 100 K at 90% efficiency.
> > Electric Heat at 14 cents per kwh will cost you $4.09 per 100 K into