|
Posted by Noon-Air on February 14, 2007, 7:18 pm
>I have a new Goodman GSH1 heat pump and the reversing will not switch
> to heat mode through the Thermostat which is a Honeywell Pro 3210D
> Non-programmable thermostat. If I disconnect the wires (orange) at
> the out side unit it goes to heat mode no problem, so the valve is not
> stuck. I and another HVAC guy have gone over the wiring about 5 times
> and everything is connected correctly. I think it may be a bad or mis-
> matched thermostat (thermostat is new) So I am leaning toward being
> mis-matched even though the Goodman distributor sold me the entire
> setup. Anyone have similar problems or have a solution?
yup
Call the folks you bought it from and have them come fix it.
|