|
Posted by Bubba on February 10, 2007, 2:21 pm
On 10 Feb 2007 10:54:04 -0800, mps1970@hotmail.com wrote:
>I have a new Goodman GSH1 heat pump and the reversing will not switch
>to heat mode through the Thermostat which is a Honeywell Pro 3210D
>Non-programmable thermostat. If I disconnect the wires (orange) at
>the out side unit it goes to heat mode no problem, so the valve is not
>stuck. I and another HVAC guy have gone over the wiring about 5 times
>and everything is connected correctly. I think it may be a bad or mis-
>matched thermostat (thermostat is new) So I am leaning toward being
>mis-matched even though the Goodman distributor sold me the entire
>setup. Anyone have similar problems or have a solution?
Yep. Its the thermostat. Replace it. Its almost always the thermostat.
Bubba
"If I only had a nickel for every thermostat thats bad"
|