|
Posted by Eric on July 7, 2008, 3:10 am
Jim Rainfordson wrote:
> Okay, I want more water pressure. I bought two separate under-the-
> sink water filters. Not a dual unit, but two self contained water
> filter units. Now I want to hook them up so that water flows
> separately through each, then joins back together again before exiting
> the kitchen faucet.
>
> The unit is housed with 3/8" FPT (plastic) holding a 3/8MPT to 1/4
> compression male (plastic). Do I have to step it down to 1/4 or can I
> use the 3/8" FPT? I'm wondering if putting too much pressure on the
> unit (by not bottlenecking it to 1/4"C) will cause it to function
> improperly. I don't care about the pressure in this regard. I'm
> getting the increase by using two units instead of the usual one.
> However, I do want to use less fittings.
>
> What about exiting the units? If 1/4 C is the intake then that's the
> bottleneck, so at that point it shouldn't matter if I use 1/4"C or
> 3/8" FPT, right?
>
>
> The faucet I have in mind is a single handle with standard 1/2 MPT.
>
> Anyone know if the units themselves automatically act as a back flow
> preventer? If not I'd be worried unequal pressure might blow water
> back and forth from filtered to unfiltered water, not that I can see
> any terrible consequences.
>
> advice or criticism welcomed
> thanks
pressure will be maximum when the faucet is off, stopping down the fitting
will reduce your flow. When you open the faucet the pressure will drop as the
flow increases. So... if your filters can handle the pressure when there is no
flow they will be fine when there is a flow.
Also, the flow will balance out between the 2 filters, if one is more plugged
than the other the flow though the plugged one will be less. You wont get
backflow here, high side pressure will be the same on both units.You could
possibly get some micro drift when the faucet is off, but who cares, its
drinking water and it will only be refiltered agin when the faucet comes on.
The bottleneck will be the smallest ID, try to maintain the 3/8 if you can.
A short run of smaller ID has less effect than a longer run.
Seems to me, either you have a filter that doesnt have a very high
through-put(is it designed for this type of use?), a low pressure water
supply, or a plugged faucet/aerator.
Eric
| 
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML Sitemap