|
Posted by Tom G on July 15, 2006, 10:59 pm
> Hello all,
> I've had a Mastercut riding mower for about 10 years that finally
> shredded a belt.
> I have a new belt, but it looks like it's harder to do than I
> anticipated.
> The belt has to go around several things and I have no idea how to do
> this.
> Can anyone give me some instruction on how this is done safely and
> properly?
I suspect that if you just begin to install the belt, you'll figure out how
it goes. I think if it's done wrong you will either not be able to fit it
onto the drive puller or it will be too loose and fall of that pulley. I
just replaced the belt on a Deutz-Allis and had no idea how it went but once
I started, it was obvious it could only go one way. Good Luck and don't
pinch a finger between a pulley and the belt.
Tom G.
| 
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML Sitemap
> I've had a Mastercut riding mower for about 10 years that finally
> shredded a belt.
> I have a new belt, but it looks like it's harder to do than I
> anticipated.
> The belt has to go around several things and I have no idea how to do
> this.
> Can anyone give me some instruction on how this is done safely and
> properly?