|
Posted by Stormin Mormon on October 11, 2006, 9:40 am
You can use either 7/8 or 1 inch holesaw.
Measure the thickness of the door, use the center hole which is
labelled for your door thickness. If your door is 1 3/4 thick, use the
center hole which is labelled 1 3/4.
Essentially, drill in the center of the door edge. Not closer to
either side of the door.
--
Christopher A. Young
You can't shout down a troll.
You have to starve them.
.
It says:
"Mark center of door thickness for hole diameter 7/8" or 1" for
circular drive in".
And then there is a picture below with two bulls-eye and one that says
1 3/4" and 1 3/8".
Can you please help me make sense of this?
Many thanks in advance.
Aaron Fude
| 
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML Sitemap