|
Posted by z on April 4, 2008, 1:13 pm
>
>
>
>
>
> > > I have just discovered that my basement floor has a 3-foot long crack
> > > in it. =A0This crack has begun to seep water through it slowly. The
> > > crack "starts" from a PVC pipe that is in a vertical direction which
> > > is used as my washing machine's drain. =A0On the other side of the cra=
ck
> > > (but not directly where the crack ends), there is a drain that goes
> > > under my basement floor.
>
> > > Is it possible that there is a pipe underneath my basement floor that
> > > connects the drain to this PVC pipe that may have burst? =A0If there i=
s
> > > a pipe and it has burst, =A0would applying that basement floor/wall
> > > crack patch stuff (and then sealant) fix the problem? =A0Or, should I
> > > use a jackhammer to get to that pipe and replace the pipe and then re-=
> > > apply concrete to the area? =A0Any other suggestions?
>
> > what's the purpose of the PVC next to the crack? =A0Is it a drain? =A0If=
so, I
> > doubt that there'd be enough volume going through in to make that much
> > moisture.
>
> Yes, the PVC is a drain for the washing machine. =A0But, as mentioned in
> my first post, there's a floor drain about 3-4 feet away from this PVC
> pipe at the "other end" of the crack.
>
> One other thing to note, when the washing machine is emptying water
> out during the spin cycle (just prior to the rinse cycle), soap suds
> bubble up through the floor drain. =A0This leads me to believe that the
> drain and the PVC pipe that you're seeing in the picture are connected.- H=
ide quoted text -
>
> - Show quoted text -
hmmm... well, if there's no soap bubbling up through the floor, that's
a good sign. do the dye trick like the guy said. also, does water come
up from the crack when the washing machine hasn't been run? it seems
fairly obvious that there isn't any pressure in the pipe when the
machine isn't actually draining, so that would be the only time it
would leak, if it leaks.
|