|
Posted by Norminn on October 28, 2007, 5:44 pm
jim evans wrote:
> I've struggled with this problem for years. It is a segmented plywood
> wood or laminated wood garage door that's raised vertically by a
> torsion spring. The paint at the bottom of segments (particularly the
> next to the bottom one) cracks. The cracks are roughly vertical.
> I've repaired this 2-3 times in the past, but it keeps coming back.
>
> I'm fairly sure the problem is that rainwater seeps into the seam
> between two segments and runs down the plies. I've tried to seal the
> upper edge of the segments with paint but it never stays. When the
> door is all the way up or down the segment edges come together (touch)
> and the paint sticks to the other edge and is torn/pulled off when the
> segments separate while opening/closing. I've tried sealing the edges
> with this stuff and injecting it into the paint cracks before
> repainting http://www.minwax.com/images/Products/hardener.jpg, but it
> doesn't seem to do anything at all. I have also injected caulk into
> the cracks.
>
> Here are the best pictures I've been able to make to illustrate this
> problem, but they don't make it clear.
> http://img152.imageshack.us/img152/8839/garagedoorrf8.jpg
>
> Note also the bolts that are rusting. I've replaced most of the
> rusted bolts over time. I always to seal the bolts from water by
> filling the bolt holes liberally with caulk, to the point it squeezes
> out in all directions. It helps, but it doesn't prevent rerusting.
>
> If I can't come up with something this time that works I guess I'm
> going to have to replace this door that's in good condition otherwise.
>
> Anybody have any new ideas?
Looks like kind of a mess. Your rusty bolt problem may be aggravated by
sticking then into caulk .. the uncured caulk could make them rust.
Does the door get full sun exposure? More sun at the bottom would help
explain your paint problems. Too hot, shrinks and expands, cracks hard
rigid coat of paint.
If the wood isn't rotted, I would strip all paint from the worst section
and sand it. Sand the rest. Have to do this when weather is warmish
and DRY. When the wood is thoroughly dry, put a quality alkyd primer
on. Let that cure at least 2-3 days. Keeping the bottom of the door
off the ground until finished. Put flexible, paintable caulk (light
application) into the seams between the panels and frame. Let caulk
cure. Paint two coats quality latex semi-gloss paint.
| 
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML Sitemap