Home Page link

Garage door spring question

Home Repair - - If it ain't broken, don't fix it. Otherwise look here. 

Page 4 of 5       < 1 2 3 > last >> Bookmark this page:  YahooMyWeb Yahoo!  Google Google  Windows Live Favorites Windows Live  del.icio.us del.icio.us  digg digg  Add to Netscape Netscape
Subject Author Date
Garage door spring question Robert Barr 05-21-2007
If you were  Registered and logged in, you could reply and use other advanced thread options
Posted by Robert Barr on May 22, 2007, 8:19 pm
AZ Nomad wrote:

>
>
>>Some jobs are worth paying for. Unless you don't mind loosing a hand or
>>an arm... Depends I guess.
>
> or your head.

AAAAAAAAHHH! SHI#$%$T, MY HEAD MY HEAD MY HEAD MY HEAD MY HEAD MY
HEAD! AND I CAN'T SEE! OWWWWWW, MY HEAD MY HEAD!

Anyone know a good neurosurgeon? Oh WHY didn't I listen to that POS
waste product internet troll? Just because he contributes nothing but
belligerent OBTUSE remarks, I should have listened to the sewage THIS
TIME! MY HEAD MY HEAD MY HEAD MY HEAD!

------------------------------------------------------------------

Actually it wasn't bad at all. The replacement springs at Home Depot
are much smaller in diameter than the originals, and they're physically
shorter, so I needed a little slack in the cables to balance the two
sides. It looks like it stretches farther, which isn't possible because
the geometry hasn't changed at all -- so it stretches exactly half the
height of the door. Like always. The door balances at about waist
height, which is about right.

When the original tore loose it also ripped the bracketry from the
framing lumber, so that had to be reinforced and restored. That took
more time than installing the springs.

The new springs come with safety cables, which is how it should have
been all along.

It wasn't a difficult job, but it was a CREEPY job, especially after
everyone's dire warnings of violent death and dismemberment. Closing
the door the first time was a little unnerving, but it's sturdier than
it was originally and now it has safety cables.

PexSupply Full Banner
Posted by Steve Barker on May 22, 2007, 9:07 pm
So now he's losing his head? He's going to fall off the ladder onto a
guillotine or something?

--
Steve Barker





>
>
>>On Tue, 22 May 2007 00:57:23 +0000, Robert Barr wrote:
>
>>> I need to replace the extension springs in my garage door. I weighed
>>> the door (properly, a few times) and came up with 145 pounds. Do I use
>>> 140 pound springs, or 150?
>
>>Some jobs are worth paying for. Unless you don't mind loosing a hand or
>>an arm... Depends I guess.
> or your head.



Posted by Rich256 on May 22, 2007, 11:12 pm
wrote:
> So now he's losing his head? He's going to fall off the ladder onto a
> guillotine or something?
>
> --
> Steve Barker
>
>
>
>
>
>
> >>On Tue, 22 May 2007 00:57:23 +0000, Robert Barr wrote:
>
> >>> I need to replace the extension springs in my garage door. I weighed
> >>> the door (properly, a few times) and came up with 145 pounds. Do I use
> >>> 140 pound springs, or 150?
>
> >>Some jobs are worth paying for. Unless you don't mind loosing a hand or
> >>an arm... Depends I guess.
> > or your head.- Hide quoted text -
>
> - Show quoted text -

First one I replaced were on a very heavy solid one piece door. It
had a mechanism on each side where the springs were fastened near the
floor at the door and then slanted back from the floor at about a 45
degree angle.

They were about 2 inches in diameter. With the door braced open
they needed to be stretched about three inches to get hooked up
properly. Even with a long bar I was not able to stretch them that
much. I was about ready to give up. Then got an idea. I hooked them
up the best I could and closed the garage door. With the springs
fully stretched I put nails between many of the rungs. Braced the
door open again and now the spring was about three inches longer than
before. Hooked it up where it should be, closed the door and took out
the nails.

The next time they broke I replaced each big spring with two smaller
ones that could be stretched by hand.

The spring on a neighbors door broke near the floor and it went
through the garage roof and landed in his back yard.

The daugher of another neighbor was seriously injured when one broke
while she was standing nearby.


Posted by Steve Barker on May 22, 2007, 11:19 pm

>
> The spring on a neighbors door broke near the floor and it went
> through the garage roof and landed in his back yard.


MY ASS!



Posted by Edwin Pawlowski on May 22, 2007, 11:23 pm

> The spring on a neighbors door broke near the floor and it went
> through the garage roof and landed in his back yard.
>
> The daugher of another neighbor was seriously injured when one broke
> while she was standing nearby.
>

That is why they run a cable through the springs now. Keeps them from
flying.



Page 4 of 5       < 1 2 3 > last >>
Similar ThreadsPosted
Garage Door Spring Rips Garage Apart July 7, 2007, 2:30 pm
Garage Door Spring June 13, 2005, 2:15 pm
Re: Broken garage door spring July 2, 2006, 9:34 am
Broken garage door spring November 15, 2006, 6:02 pm
Garage door torsion spring replacement May 29, 2006, 12:51 pm
Extension spring garage door - tensioning is not working!! September 15, 2007, 8:01 pm
Garage torsion spring February 2, 2007, 10:08 am
Garage Spring Stretching Tool? May 7, 2007, 8:49 pm
Garage door question March 16, 2007, 3:28 pm
New garage door question(s) September 29, 2007, 7:37 pm

Contact Us | Privacy Policy

XML SitemapXML Sitemap