|
Posted by Ulysses on March 17, 2007, 2:35 pm
The governor gear on my Honda GX270 9HP engine (for generator) is evenly
worn with a groove along the middle of the teeth (instead of being straight
along the edge as seen from the side there is a "U" shaped groove). Is this
considered normal wear for a governor gear of this sort or did I do
something wrong when I reassebled the engine? I replaced the piston and
exhaust valve and when I replaced the crankcase cover I did not use a gasket
but used some blue silicone instead. Does the governor gear need that
couple thousandths of an inch? Is there some way to check the governor gear
alignment during reassembly? The engine ran great at first then started
having governor problems and finally was trying to run away at full speed.
Thanks.
| 
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML Sitemap