|
Posted by on June 11, 2006, 1:07 am
the green device is the flow restrictor.
refer to:
http://ths.gardenweb.com/forums/load/bath/msg1011162929979.html?4
i just followed these instructions, from that page:
--
However, if you find that you need to repair or replace the shower head
flow restrictor, you would remove the section of the showerhead that
attaches to the shower arm (this is the piece that you attached to the
pipe where your old shower head was, and now acts as the source for the
water as well as the holder of the hand-held showerhead). This piece is
basically a pipe that is shaped like an upside-down "L". At the input
side, there is a small un-screw-able black filter that keeps large
particles from getting into your hansgrohe. You should remove this to
inspect your flow restrictor.
Behind where the filter used to be you will see a small piece of green
plastic that fits very tightly into the pipe, and has a very small
black o-ring. If you suspect that your flow restrictor is operating
incorrectly, you could unscrew this section of pipe off of the ball
joint to freely access the flow restrictor. You will now have a small
section of pipe, with the flow restrictor lodged in it. Using the back
of a pencil, or a large screwdriver or anything else that will fit in
the pipe, you can push the flow restrictor out.
--
there seems to be a slightly greater volume of water flowing now, but i
won't know for sure until after tomorrow's shower. :)
hope this helps.
Thomas G. Marshall wrote:
> C & E said something like:
> > "Thomas G. Marshall"
> >>
> >> Ok, this subject has come and gone repeatedly in various forms. In my
> >> case it is the Hansgrohe Turbo=B3 massage.
> >>
> > <snip>
> >
> >> Also, there is a plastic screen at the very outset: right in between t=
he
> >> shower arm and the shower arm mount. This one confuses me: It looks l=
ike
> >> a very restrictive screen---all plastic with very *very* small holes.
> >> Yet
> >> having it in and taking it out seem to do nothing to the water
> >> flow---I'll
> >> need to experiment more on that one, but I left it in for now.
> >
> > This is probably just ofr aeration so that the water is dispersed.
> >
> >>
> >> Finally the handle itself has a water hole opening that is substantial=
ly
> >> smaller than the bore of anything leading up to it. Is it possible th=
at
> >> /this alone/ is the 2.5 GPM restrictor---a silly little hole? I may j=
ust
> >> drill the thing larger out of principal alone :)
> >
> > I'm gonna guess that you're right about that. The little add-on
> > restrictors
> > are nothing more than a plastic piece with a small
> > hole. You could drill it out a little at a time to see when you get the
> > desired result. Just remember, once you drill you can't go back
> >>
> >> Thanks
> >>
> >>
> >> --
> >> Sometimes life just sucks and then you live.
>
> It is larger than the 2.5 GPM restrictor I found in my old cheapie shower
> heads. That was just a thin metal disk with a very small hole dead cente=
r=2E
> This one is more like 1/4 " in diameter.
>
> Is it possible that there is a limiter stuffed deep into the handle itsel=
f?
>
> --
> "So I just, uh... I just cut them up like regular chickens?"
> "Sure, just cut them up like regular chickens."
| 
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML Sitemap