If you were Registered and logged in, you could reply and use other advanced thread options
Posted by Ian Pilkington on October 5, 2006, 4:21 am
I recently removed one of my radiators to aid in decorating a room. I
managed this no problems and my heating system still worked fine. When
I came to put the radiator back, I followed what i thought was the
correct process. The radiator filled up, got the water to drip from the
bleed valve, no leaks from any joins and the radiator started to get
hot. The pressure had got low on the boiler (a worcester 28i) so
increased the pressure back to what it should be. However now i have no
heating or hot water. When I switch the heating on or turn a hot water
tap the boiler ignites as normal (or at least it sounds normal) but I
get no hot water coming through either the taps or the radiators. Can
someone tell me what I'm doing wrong?
Cheers
Ian
--
Ian Pilkington
Posted by Speedy Jim on October 5, 2006, 9:19 am
Ian Pilkington wrote:
> I recently removed one of my radiators to aid in decorating a room.
<SNIP>
Post to this group as well:
UK.D-I-Y
Posted by Sev on October 5, 2006, 10:42 am
Is the water feed/ make up valve open? (to refill the system) Sounds
like it might not be.
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML Sitemap