If you were Registered and logged in, you could reply and use other advanced thread options
|
Posted by on January 5, 2007, 5:36 pm
Hello,
My water heater rusted and leaked and spewed water all over my nice
floor. It has a "pan" underneath it, but this was not able to contain
all the water that spewed out. I have a new water heater now, with a
new pan underneath, but I'm trying to avoid this from happening again.
I'm wondering if there is some sort of a "sup-pump" that I can use to
take the water out of the house when the new water heater leaks? I'm
told that there are moisture alarms, but are they any good? This still
will not take the water away if the water heater leaks. I'm open to
the "BEST" solution...something that will avoid this situation in the
future.
Thanks.
|
|
Posted by on January 5, 2007, 5:46 pm
samadams_2...@yahoo.ca wrote:
> Hello,
>
> My water heater rusted and leaked and spewed water all over my nice
> floor. It has a "pan" underneath it, but this was not able to contain
> all the water that spewed out. I have a new water heater now, with a
> new pan underneath, but I'm trying to avoid this from happening again.
> I'm wondering if there is some sort of a "sup-pump" that I can use to
> take the water out of the house when the new water heater leaks? I'm
> told that there are moisture alarms, but are they any good? This still
> will not take the water away if the water heater leaks. I'm open to
> the "BEST" solution...something that will avoid this situation in the
> future.
>
>
> Thanks
The pan for my water heater has a 2" pipe that runs through the wall ,
so if the pan starts to fill with water it will drain outside.
A sump pump would work , there are some with a water sensor that are
made for that purpose , but you may get a LOT of water pouring out if
the tank fails.
|
|
Posted by professorpaul on January 5, 2007, 6:34 pm
1. I make a tour of the house/fitting/systems about once a month to
check on things.
2. I turn the water OFF when I leave the house for more than a day.
After a couple of nasty surprises over the years, just keeping on top
of things helps, especially if it is an older house. Most leaks give
some warning before you have a major flood.
|
|
Posted by DerbyDad03 on January 5, 2007, 7:44 pm
The "BEST" solution to avoid getting water in the house from a leaky
hot water heater would be to put the hot water heater outside the house
in a location that is graded such the water flows away from the house.
Foolproof. Can't fail.
If that's not feasible, the next "BEST" solution would be to find the
balance between a sump and a sump pump such that flow rate of the pump
just slightly exceeds the discharge rate of the leaking hot water
heater. Since you can't predict the discharge rate of the leaky heater,
you'll have to plan for the worst case.
Let's assume a catastrophic failure of a 50 gal heater. When the unit
bursts and all the water spews forth instantaneously, you'll need a set
up that is somewhere beween a very small sump with a 50 "gallon per
instant" pump and a 50 gallon sump with a pump that takes it's sweet
time moving the water out of the house. Keep in mind that the water
heater and the sump have to be positioned in such a manner that
regardless of where the water leaks from, it ends up in the sump.
I guess I would opt for a 50 gallon sump with the heater installed
inside the sump. Seems like the most failsafe way to contain the water
until the pump can move it to an outside location.
OK, I'll bet you think I'm kidding. Alas, if you really want to avoid
getting any water on your floor in the future, you have to plan for the
worst case. Other than that, the "BEST" you can hope for is that a
smaller sump and sump pump will suffice for whatever type of leak
actually occurs. Think back to your original problem. How fast did the
water leak out of the heater? If you know that answer, and feel safe
assuming that that is the most probable rate of discharge, then find
the combination of sump and sump pump to meet that critera, keeping in
mind that the water has to actually end up in the sump in order for the
pump to move it out of the house.
samadams_2006@yahoo.ca wrote:
> Hello,
>
> My water heater rusted and leaked and spewed water all over my nice
> floor. It has a "pan" underneath it, but this was not able to contain
> all the water that spewed out. I have a new water heater now, with a
> new pan underneath, but I'm trying to avoid this from happening again.
> I'm wondering if there is some sort of a "sup-pump" that I can use to
> take the water out of the house when the new water heater leaks? I'm
> told that there are moisture alarms, but are they any good? This still
> will not take the water away if the water heater leaks. I'm open to
> the "BEST" solution...something that will avoid this situation in the
> future.
>
>
> Thanks.
|
|
Posted by on January 5, 2007, 9:33 pm
I haven't seen pumps made specifically for this purpose, but you could
probably find one that would work. First, I'd look into any possible
gravity drain type arrangements. Like a simple drain to outside or
down to a basement sump pump, etc.
The alarms are $10, they work and I have one, but they obviously only
help if the leak starts out slow.
|
Page 1 of 2 1 2 > last >>
| Similar Threads | Posted | | oh no!!! now the hot water heater is leaking | September 3, 2005, 5:22 pm |
| HELP HELP anyone out there? Unions leaking on new hot water heater | June 17, 2008, 12:15 am |
| HELP! Water heater KEEPS leaking at top fitting - argh! | August 10, 2005, 10:06 am |
| Question about water heater pressure relief valve is leaking | March 23, 2006, 12:38 am |
| AC water leaking | July 16, 2007, 4:03 pm |
| AC water leaking | July 16, 2007, 6:20 pm |
| Fridge leaking water | January 1, 2006, 5:56 pm |
| Freezer leaking water | January 10, 2006, 3:47 pm |
| Central AC leaking water | September 26, 2006, 4:01 pm |
| Water leaking from flue? | May 16, 2007, 5:29 pm |
|
|
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML Sitemap