New cased A-coil and furnace (alignment)

Posted by Puddin' Man on March 23, 2006, 7:14 pm

Re: New cased A-coil and furnace (alignment)
Hi,
I recently had a contractor replace my old Carrier
furnace, etc with lo-end Heil eqpt.
The matching cased A-coil unit sits slightly akilter on the furnace.
Viewing from the front, the coil unit is flush on the left side.
Extends about 1/4 " over the furnace edge on the right. On the
front and back, one corner is flush and the other is 1/4" off.
How do the cased A-coil units fit onto the furnace? Are
they supposed to align perfectly?
I've paid the contractor (evidently a mistake on my part,
should've held back something), and am wondering if
this constitutes poor workmanship that might justify
a BBB complaint. As near as I can tell, they didn't do a
very good job except on the plenum, which *looks* good, but
might be the reason the A-coil doesn't align.
Any/all suggestions/info much appreciated.
Cheers,
Puddin'

Similar Threads	Posted
Porch alignment	July 6, 2009, 5:30 pm
Storm Door Out of Alignment	August 30, 2005, 8:51 am
Storm Door Out of Alignment	July 14, 2006, 10:40 am
Fixing drain alignment	September 25, 2006, 2:47 pm
door latch alignment on striker plate	October 15, 2005, 9:23 am
Garage door lift bracket - alignment out of whack?	September 12, 2007, 11:41 pm
slow leak at iron pipe threads: how to get it tight when alignment is needed?	October 29, 2007, 10:41 am
Old Lennox Furnace - Model GH6 100T (maybe thermostat maybe furnace problem)	November 6, 2006, 1:32 pm
run my oil forced air furnace once a month in the summer to keep the furnace from rusting	July 4, 2006, 9:59 am
Where do I get this part for an oil furnace? Has the furnace died?	October 26, 2009, 1:48 am