If you were Registered and logged in, you could reply and use other advanced thread options
|
Posted by Don on February 18, 2006, 12:12 am
> After the last one had me going, I can't wait to see how this one
> transpires..
> Searcher
>
The last one In retrospect dumping the salt OUT OF the bags into wheel
barrow ( clean) spreading around the pool with shovel might of been a better
idea, to bad I didn't think of that.
|
|
Posted by on February 18, 2006, 1:43 am
> After the last one had me going, I can't wait to see how this one
> transpires..
> Searcher
>
The last one In retrospect dumping the salt OUT OF the bags into wheel
barrow ( clean) spreading around the pool with shovel might of been a better
idea, to bad I didn't think of that.
|
|
Posted by Don on February 18, 2006, 3:26 am
> After the last one had me going, I can't wait to see how this one
> transpires..
> Searcher
>
The last one In retrospect dumping the salt OUT OF the bags into wheel
barrow ( clean) spreading around the pool with shovel might of been a better
idea, to bad I didn't think of that.
|
|
Posted by RicodJour on February 18, 2006, 10:51 am
> After the last one had me going, I can't wait to see how this one
> transpires..
> Searcher
>
The last one In retrospect dumping the salt OUT OF the bags into wheel
barrow ( clean) spreading around the pool with shovel might of been a better
idea, to bad I didn't think of that.
|
|
Posted by Joshua Putnam on February 18, 2006, 12:01 pm
> After the last one had me going, I can't wait to see how this one
> transpires..
> Searcher
>
The last one In retrospect dumping the salt OUT OF the bags into wheel
barrow ( clean) spreading around the pool with shovel might of been a better
idea, to bad I didn't think of that.
|
Page 1 of 2 1 2 > last >>
| Similar Threads | Posted | | Mounting Sheet Metal? | March 26, 2008, 9:14 am |
| Sheet metal screw stripped out | September 2, 2006, 11:29 am |
| Cutting sheet metal question | December 18, 2006, 6:32 am |
| Re: Painting Galvanized Sheet Metal | April 9, 2008, 11:22 am |
| Re: Painting Galvanized Sheet Metal | April 9, 2008, 11:41 am |
| Re: Painting Galvanized Sheet Metal | April 9, 2008, 12:22 pm |
| Cutting openings in sheet metal ducts. | October 21, 2007, 8:41 pm |
| Re: Sharp sheet metal screws overhead. | August 21, 2008, 7:44 am |
| Re: Sharp sheet metal screws overhead. | August 21, 2008, 6:23 pm |
| Re: Sharp sheet metal screws overhead. | August 22, 2008, 10:15 am |
|
|
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML Sitemap