Roof torch.

Posted by joevan on October 3, 2009, 6:28 pm

My roofing torch was not putting out much flame the other day so I
used a fine needle like tool with a handle to open up the nozzel. I
keep it outside with the tank covered with greenhouse plastic. This
time I sprayed some wd40 on the nozzel when I put it down for a spell.
Should I put some oil on the nozzel too or will the wd 40 be
sufficient.

Posted by Stormin Mormon on October 5, 2009, 8:45 am

You should wrap the nozzle in cotton, and then wrap with tar
paper, and soak the cotton in gasoline. Sprinkle on
tequilla, and some cinnamon.

Oh, you didn't say "sufficient to...... do...... what......"

--
Christopher A. Young
Learn more about Jesus
www.lds.org
.

My roofing torch was not putting out much flame the other
day so I
used a fine needle like tool with a handle to open up the
nozzel. I
keep it outside with the tank covered with greenhouse
plastic. This
time I sprayed some wd40 on the nozzel when I put it down
for a spell.
Should I put some oil on the nozzel too or will the wd 40 be
sufficient.

Posted by joevan on October 5, 2009, 8:53 am

On Mon, 5 Oct 2009 08:45:04 -0400, "Stormin Mormon"

>You should wrap the nozzle in cotton, and then wrap with tar
>paper, and soak the cotton in gasoline. Sprinkle on
>tequilla, and some cinnamon.
>Oh, you didn't say "sufficient to...... do...... what......"

To protect it so it will not clog up again.
I don't want to eat it, just keep it from rusting again.

Similar Threads	Posted
Hot Mop or Torch Flat Roof?	September 19, 2008, 12:16 am
Roofing - Wish to put 90lb rolled over existing torch-down roof.	May 16, 2008, 8:45 pm
Blow torch, propane torch	March 19, 2006, 11:29 pm
Propane torch?	March 19, 2007, 3:56 pm
Thermoplastic/Torch/Mop?	November 22, 2008, 6:01 pm
can propane torch be used to fic the blacktop	January 9, 2006, 10:23 pm
Which BernzoMatic Torch Head?	July 18, 2006, 9:58 am
Building a gas Tiki Torch	November 9, 2006, 3:17 pm
Propane/MAPP torch recommendation, please	August 28, 2007, 8:45 am
Propane torch head with pipe at right angle	November 15, 2006, 6:11 pm