If you were Registered and logged in, you could reply and use other advanced thread options
|
Posted by Zootal on March 8, 2007, 9:11 pm
I'm preparing to put in a sidewalk along the back of my house, maybe 30 or
40 feet total. I have a big pile of aggregate, lotsa cement power, a pile of
sand, and some basic cement working tools. What I don't have is any
pracitcal experience. Are there any good resources for DIY sidewalk makers,
and any practical advice anyone would like to share?
|
 
| |
Posted by Don Young on March 8, 2007, 9:28 pm
> I'm preparing to put in a sidewalk along the back of my house, maybe 30 or
> 40 feet total. I have a big pile of aggregate, lotsa cement power, a pile
> of sand, and some basic cement working tools. What I don't have is any
> pracitcal experience. Are there any good resources for DIY sidewalk
> makers, and any practical advice anyone would like to share?
>
Do a small section at a time, perhaps 3 to 5 feet. Make joints between
sections so that it will crack in the joints and not elsewhere. It will
probably need to be 3 to 4 inches thick to not break up later. Use as little
water as possible and still be able to smooth the cement. Keep it damp and
protected from the sun for a few days. There are lots of DIY books and other
information on cement work. Try one section and see how it turns out before
tackling the whole job.
Don Young
|
|
Posted by Joseph Meehan on March 9, 2007, 8:01 am
Zootal wrote:
> I'm preparing to put in a sidewalk along the back of my house, maybe
> 30 or 40 feet total. I have a big pile of aggregate, lotsa cement
> power, a pile of sand, and some basic cement working tools. What I
> don't have is any pracitcal experience. Are there any good resources
> for DIY sidewalk makers, and any practical advice anyone would like
> to share?
That is a lot of area. You are likely going to find that it is going to
be cheapest to order readymix concrete from a truck. One in-experienced
person is not going to be able to keep up with the truck and the job.
Finishing concrete right (to look good and to last a long time) takes
not only book learning, but hands one experience with someone who knows.
Check around with your neighbors to see if anyone has the experience. Also
check for a couple of good strong high-school boys (or girls) for some grunt
work and a good learning experience for them.
--
Joseph Meehan
Dia 's Muire duit
|
|
Posted by Roger Shoaf on March 9, 2007, 1:03 pm
> I'm preparing to put in a sidewalk along the back of my house, maybe 30 or
> 40 feet total. I have a big pile of aggregate, lotsa cement power, a pile
of
> sand, and some basic cement working tools. What I don't have is any
> pracitcal experience. Are there any good resources for DIY sidewalk
makers,
> and any practical advice anyone would like to share?
>
>
One idea is to make your own pavers. Make or buy molds that you can set up
in your garage. Have enough molds to use up one batch of concrete. Each
night you mix one batch, cast your pavers and in short order you have enough
for your side walk.
On the weekends you can prepare your ground. Dig out the area you want to
have your walk and bake a nice base of crushed rock and sand over that.
Then you can set your pavers into the walk way and spread sand around to
fill the cracks.
By doing it this way future problems with tree roots, or plumbing issues are
no problem as you can always remove the pavers and get to underneath without
a jack hammer.
This method also allows you to play with color and patterns.
--
Roger Shoaf
About the time I had mastered getting the toothpaste back in the tube, then
they come up with this striped stuff.
|
|
Posted by Ook on March 10, 2007, 2:35 am
>
> One idea is to make your own pavers. Make or buy molds that you can set
> up
> in your garage. Have enough molds to use up one batch of concrete. Each
> night you mix one batch, cast your pavers and in short order you have
> enough
> for your side walk.
>
<snip>
Funny, I"ve thought of doing exactly that, and also pouring some custom
border sets also. How big would you make the pavers, and how thick? I also
looked at buying some, but the ones at the local hardware store are more
then I'm willing to pay :(
|
| Similar Threads | Posted | | DIY Advice Needed | July 13, 2005, 4:20 pm |
| tie down advice needed | August 7, 2005, 2:30 am |
| Advice needed ??? | June 23, 2005, 4:01 pm |
| plumbing advice needed | September 10, 2005, 9:54 pm |
| Irrigation advice needed | June 25, 2006, 4:43 pm |
| Marble advice needed | November 20, 2006, 9:21 pm |
| Pergola advice needed | July 12, 2007, 3:04 pm |
| Door advice needed | October 28, 2007, 12:09 am |
| Hot Tub Repair or Advice Needed | December 9, 2007, 2:26 pm |
| Advice needed for lock replacement | February 12, 2005, 3:41 pm |
|
|
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML Sitemap