|
Posted by hallerb@aol.com on February 13, 2007, 8:48 am
> Jimbo wrote:
> > Installed Titan tankless hot water heater recently and all is well,
> > with the exception that the washing machine water starts hot then gets
> > cold and will not heat back up.
>
> > I even turned off the cold water valve at the washing machine and get
> > the same result. =A0 =A0What could it be and what should I do?
>
> > Thanks
>
> Well if everything else is working properly then it has to be the flow is=
to
> low to trigger the heater to come on. Have you checked the screen on the
> inlet of the washer? There might be enough crap in there to cut down on t=
he
> flow? I run the water in the sink to get my tankless heater going and hot
> water in the lines while I'm loding the washing machine.
>
> Good luck, Rich
To check minimum flow while running washer turn on other faucet fully,
if water then heats its a minimum flow problem.
|