baseboard repainting

	baseboard repainting

Home| Search | About

Lost Password?

Home Repair - - If it ain't broken, don't fix it. Otherwise look here.

Bookmark this page: YahooMyWeb

Yahoo!

Google

Windows Live

del.icio.us digg

digg

Netscape

Subject

Author

Date

baseboard repainting

doug

07-19-2007

Re: baseboard repainting

Not@home

07-26-2007

Re: baseboard repainting

Hopkins

07-27-2007

If you were Registered and logged in, you could reply and use other advanced thread options

Posted by on July 19, 2007, 3:45 pm

I have a section of baseboard I want to repaint. It has a lot of
contours (in and out; I don't know the correct nomenclature but its
sorta fancy looking) and I want to sand/scrape it first but ordinary
sandpaper or a putty knife won't do it well. What are practical
choices to sand/scrape the old paint before repainting it? I just
thought of a hand wire brush or perhaps a wire brush (??) that is on
the end of a drill bit but I'd like to know what the pro's would use.

thanks.

Posted by Not@home on July 26, 2007, 11:11 am

Your best results would be from stripping it and scrubbing with a brass
brush (resembles a large toothbrush. Be certain to remove all stripper
before recoating. Light sanding of the smooth areas will also help, as
many strippers raise the grain.

I remove the baseboard first, as it is easier to work on that way, but
you have to be careful not to ruin the board when you are removing it,
as many of the older baseboards with contours are difficult to find and
expensive. Glue will often solve some problems, like splitting.

doug wrote:

> I have a section of baseboard I want to repaint. It has a lot of

> contours (in and out; I don't know the correct nomenclature but its

> sorta fancy looking) and I want to sand/scrape it first but ordinary

> sandpaper or a putty knife won't do it well. What are practical

> choices to sand/scrape the old paint before repainting it? I just

> thought of a hand wire brush or perhaps a wire brush (??) that is on

> the end of a drill bit but I'd like to know what the pro's would use.

> thanks.

Posted by Hopkins on July 27, 2007, 6:39 am

If you're just cleaning/scuffing the surface, go out and buy the 3M
sanding sponge -- about 1" thick and a bit bigger than a deck of
cards. It has sanding material on 4 sides.

The corners will get into the grooves and contours. They wear fairly
quickly-- the 'medium' ends up a 'fine', and the 'fine' ends up like
220 sandpaper. If they're too stiff to start, break them in by sanding
the flat areas [using all 4 sides]. If you're doing all the base in a
large room, I'd get two.

Anything heavy -- wood putty, big paint runs -- use sandpaper. Just
tear it in half widthwise, and fold each piece in half, twice, once
each way. That'll give you the folded edges you'll need to do the
grooves.

On Jul 19, 3:45 pm, doug wrote: