|
Posted by on December 10, 2006, 5:37 pm
I have a solid tapering slab that I want to even up. It was designed
to taper, as it is an outside sleeping porch (under the roofline
though) and it has a drain on one side. I want to raise it and frame
it in. SO my question is this:
I'm thinking of putting down about 1 cu yd of concrete (2 inch average
over 150 feet) to even it up. However, I need to taper from 3 inches to
0. If I put down a filler layer of concrete and then self leveler,
first roughing the surface and use a bonding compound, how thin can I
leave the taper on the edges? One inch? two inches?
I then intend to even up the whole thing by pouring self leveler over
the top. however, 1 cu yd of self leveler is way too expensive.
Any suggestions?
Andy
| 
Yahoo! 
Google 
Windows Live 
del.icio.us 
digg 
Netscape 
XML Sitemap